- Windows serial terminal over ip driver#
- Windows serial terminal over ip Pc#
- Windows serial terminal over ip windows#
When using the debug port from the kernel for the cmd redirection the error message doesn't appear and I can receive output on HyperTerminal running on the desktop PC (e.g. Thanks for response! I built the headed build for testing purposes also.
Windows serial terminal over ip driver#
If this is still the case in your build make sure you run cmd.exe from the registry using a launch command like this: "Launch50"="cmd.exe" "Depend50"=hex:14,00 It depends on device.exe, although this maybe a little too soon before the serial port driver is loaded. Also on my build i had to run cmd.exe from the start menu before i could get a command prompt on the serial interface, but it was a headed build.
I don't think you need HW flow control on either, set it to flow control off. I've been running it using the debug port from the kernel, set the com port to -1 (see below) to do this, else make sure that the devices serial port you are using is working: "OutputTo"=dword:ffffffff "COMSpeed"=dword:9600 38400 Remember the com speed is in hex, so 9600 is actually 0x9600 = 38400, in the above example the com speed is normally set by the kernel anyhow so this won't affect anything using this channel but it will for com 1->9. Please close some console applications and try again."
Windows serial terminal over ip windows#
Low on memory or too many console windows open. simple "Hello, world!" CE-based console application) the result is the following: command processor doesn't start showing the error message - "CMD cannot start. When I: 1) leave registry settings by default 2) boot Win CE OS 3) launch cmd.exe on my target device the result is the following: command processor starts correctly When I: 1) set registry settings to redirect command processor to operate over serial port 2) boot Win CE OS 3) launch cmd.exe on my target device or any console application (e.g. I also tried to attach display to my target device to test command processor shell functionality.
May be this behaviour is right and I missed some necessary steps? Need your advice on this issue.
Launched HyperTerminal on desktop PC with configuration: -connect to COM1 (in fact I tried all available serial ports) -19200 bps -8 data bits -Parity None -1 Stop bit -Flow Control Hardware I expected that when I start HyperTerminal console window will occur allowing me to operate windows ce command prompt from desktop PC, but nothing happens. Connect null modem cable between desktop PC's and my device's serial port. Set registry settings in project.reg file as you described above. Added to my WinCE 6.0 OS design image command processor shell. Hi! I've got a headless device and want to establish command line access to it.
0 kommentar(er)
